聯系我們
咨詢熱線：020-36703438
電話：020-36703438
傳真：020-36703488
郵箱：ccsopower@163.com
地址：廣州市白云區夏花二路29號（舊廣花路段）
當前位置: 首頁
» 新聞中心
蓄電池管式極板制造方法 |
| 擠膏是蓄電池管式極板制造法之二，將鉛膏灌進管內。這里用的鉛膏比較稀，只用稀硫酸與木炭粉（或硫酸鎂）與水一起和制稀鉛膏，鉛膏的視密度為3.4-3.8g/cm3擠膏后封底，板表洗滌后直接進行干燥，進人化成。板柵上剛涂填新鮮鉛膏的極板仍然很軟很粘，必須進行極板表面快速干燥，然后板間互不粘連，疊片進人一個緩慢干燥（固結）過程。這樣得到的極板力學性能好、強度高，這一強化過程叫作“固化”。這在20 世紀50 年代初作為一個特殊的工藝在世界鉛酸蓄電池行業推廣使用。這一過程中要使涂填的鉛青能與板柵表面緊密結合，又要使鉛膏粒子之間結合牢固。要使整個涂填的鉛膏進行全面結構轉型。Paste squeezing is the battery tube plate manufacturing method of two, will paste into tube. The paste is more rare, with dilute sulfuric acid and charcoal powder ( or magnesium sulfate ) together with water and preparation of thin paste, paste as the density of 3.4-3.8g/cm3 paste squeezing after sealing, sheet wash directly after drying, entering into. Plate gate just filling fresh paste plate is still soft and sticky, must undertake the plate surface, fast drying, then the board without mutual adhesion, laminated into a slowly drying process ( consolidation ). The plate has good mechanical performance, high strength, this intensive process called " curing ". In the early nineteen fifties as a special technology in the world of lead-acid battery industry to promote the use of. The process to make filling lead green with grid surface tightly, and make the paste bonding between the particles is firm. To make the filling paste overall structural transformation. |
-> 蓄電池閱讀相關文章 |
| 1 蓄電池成為今后20年最有發展前景的行業之一 |
| 2 蓄電池的巨大前景 |
| 3 現今蓄電池的使用狀況 |
| 4 蓄電池叉車的特點及市場分析 |
| 5 說說電動汽車為什么不宜用家用電源充電 |