聯系我們
咨詢熱線：020-36703438
電話：020-36703438
傳真：020-36703488
郵箱：ccsopower@163.com
地址：廣州市白云區夏花二路29號（舊廣花路段）
當前位置: 首頁
» 新聞中心
鉛酸蓄電池固化室必須滿足的條件 |
| ① 采用電熱或熱源，確保固化過程溫度可控； ② 采用濕源（發出蒸汽）確保相對濕度能在100 % -O 變化；③ 堆放生極板的疊板架。 固化與干燥兩個過程工藝要分開，對于涂膏后的極板，干燥早期可能還會有一點固化過程；而在固化過程幾乎沒有一點干燥過程。固化有助于在與鉛青接觸的板柵表面形成腐蝕層（結合層），它還能使鉛膏中游離鉛含量降至最低（3 ％以下），并且在控制溫度與濕度下確立3BS-4BS 平衡體系的建立。 ①Adopt an electricity hot or hot source, ensure that the temperature that is solid to turn process can control; ②Adopting a wet source(send out steam) ensures that the relative humidity can change in 100%-O;③Pile to living pole knothole to fold a plank. Is solid to turn to want with two dry process crafts to separate, for the pole plank after applying ointment, the aridity was probably also a little bit solid to turn process in early days;But almost have no a little dry process in the process of being solid to turn.Is solid to turn to contribute to at and the plank grid surface formation corrosion layer(combine a layer) of lead green contact, it can also make to visit to leave a lead content to decline to in the lead cream lowest(below 3%), and establish the establishment of 3 BS BSs-4s equilibrium system while controling temperature and degree of humidity. |
-> 蓄電池閱讀相關文章 |
| 1 蓄電池成為今后20年最有發展前景的行業之一 |
| 2 蓄電池的巨大前景 |
| 3 現今蓄電池的使用狀況 |
| 4 蓄電池叉車的特點及市場分析 |
| 5 說說電動汽車為什么不宜用家用電源充電 |